Electrical
2", Zinc, Water Tight Conduit Hub, Indoors Or Outdoors, Water Tight, Insulated Throat, Use To Connect Rigid Or IMC Conduit To A Load Center Or Other Metal Enclosure Where A Water Tight Joint Is Required At Knock Outs Or Slip Fit Holes, Flame Retardant Lexan Insulated Throat, Rain, Oil, & Dust Tight, Oversize Locknut Assures Vibration Proof Installation & Positive Grounding.
2 Pack, 1/2", Non-Metallic Snaptite Connector, Indoors Only, Snap In, Fits Non-Metallic Cable #14/2, #12/2, #12/3, Awg Or 2 #14/2 Awg Or Flex Cord .300 To .560" Diameter 3/8", 1/2' Knock Out, In A Dry Location, Use To Connect Non-Metallic Sheathed Cable To A Steel Outlet Box Or Other Metal Enclosure, 3/8" Size Fits 1/2" Knock Out , Snap In Design Allows For Quick & Easy Installation, No Locknut Required.
2 Pack, 3/4", Non-Metallic Snaptite Connector, Indoors Only, Snap In, Fits Non-Metallic Cable #14/2, #12/2, #12/3, Awg Or 2 #14/2 Awg Or Flex Cord .300 To .560" Diameter 3/8", 1/2 Knock Out, In A Dry Location, Use To Connect Non-Metallic Sheathed Cable To A Steel Outlet Box Or Other Metal Enclosure, 3/8" Size Fits 1/2" Knock Out , Snap In Design Allows For Quick & Easy Installation, No Locknut Required.
5 Pack, 3/8", FLX/BX Saddle Connector, Indoors Only, In A Dry Location, Used To Connect Flexible Metallic Conduit, AC, MC & Non-Metallic Sheathed Cable To A Steel Outlet Box Or Other Metal Enclosure, 3/8" Size Fits 1/2" Knock Out , Suitable For: #14-2 To The Largest Size Fit Table Non-Metallic Sheathed Cable, #14-2 With Ground Steel & Aluminum Armored Cable, 470" Diameter, 3/8" Steel Flexible Metal Conduit, Aluminum Continuous Corrugated Metal Clad Cable 0.510-0.620"Diameter, Aluminum Smooth Sheath Metal Clad Cable 0.410-0.500" Diameter, Aluminum Interlocked Metal Clad Cable 0.462-0548" Diameter, Steel Interlocked Metal Clad Cable 0.422-0552" Diameter.
10 Pack, 1 Hole Strap, For 12/2, 14/2, Indoors Or Outdoors, Used To Secure Non-Metallic Sheathed Cable To A Wood, Masonry Or Similar Surface, Use To Secure Service Entrance Cable To A Wood, Masonry Or Similar Surface.
2 Pack, 1/2", Rigid Compression Connector, For Indoors, Used To Join Threadless Rigid Or IMC Conduit To A Steel Outlet Box Or Other Metal Enclosure, Concrete Tight.
2 Pack, 3/4", Rigid Compression Connector, For Indoors, Used To Join Threadless Rigid Or IMC Conduit To A Steel Outlet Box Or Other Metal Enclosure, Concrete Tight.
10 Pack, 1/2", Plastic, Snap In Stud Bushing, Indoors Only, Use To Protect Non-Metallic Cable From Damage When Running Cable Through Metal Studs, Fits A Round Pre-Punched Metal Stud Opening.
10 Pack, 3/4", Plastic, Snap In Stud Bushing, Indoors Only, Use To Protect Non-Metallic Cable From Damage When Running Cable Through Metal Studs, Fits A Round Pre-Punched Metal Stud Opening.
5 Pack, 1/2", Non-Metallic Plastic Cable Connector, Indoors Only, Fits Non-Metallic Cable: #14/2, #10/3, Use In A Dry Location, Use To Connect Non-Metallic Sheathed Cable To A Steel Outlet Box Or Other Metal Enclosure.
5 Pack, 3/4", Non-Metallic Plastic Cable Connector, Indoors Only, Fits Non-Metallic Cable: #14/2, #10/3, Use In A Dry Location, Use To Connect Non-Metallic Sheathed Cable To A Steel Outlet Box Or Other Metal Enclosure.
1/2", Non-Metallic Strain Relief Connector, Indoors Only, Fits Cord Range .235" - .400", Use To Connect S, SO, ST, SJ, SJO & SJT Cord To An Steel Outlet Box Or Other Metal Enclosure.
3/4", Non-Metallic Strain Relief Connector, Indoors Only, Fits Cord Range .410" - .740", Use To Connect S, SO, ST, SJ, SJO & SJT Cord To An Steel Outlet Box Or Other Metal Enclosure.
1-1/4-3", UPC/PT, Adjustable Wire Holder, Indoors Or Outdoors, Use As A Holding Device For The Incoming Service Entrance Wires, Mounts Below The Overhead Service Entrance Cap.
1", Steel, EMT Raintite Connector, For Outdoors, Use To Connect EMT Conduit To Steel Outlet Box, Load Center, Or Other Metal Enclosure In A Wet Location, Concrete Tight & Raintight.